Attaching The Wall Bracket - Cleanmaxx PC-P008E Mode D'emploi

d
6. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
7. Remove the battery from the charging station.

Attaching the Wall Bracket

PLEASE NOTE!
■ Use the fastening material supplied to hang up the wall bracket. If you are unsure
whether the fastening material supplied is suitable for your wall, seek advice from a
specialist stockist.
■ Hang the wall bracket in a secure and solid place.
■ Before drilling, ensure that there are no pipes or cables behind the intended drilling
point.
1. Place the wall bracket on the wall and mark three drill holes (two at the top and one
at the bottom).
2. Drill holes into the wall and insert wall plugs.
3. Screw the wall bracket onto the wall.
1. Switch off the device and remove the battery (4) as fol-
lows: Press the release button on the battery (see picture)
and pull the battery out of the device at the same time.
2. Insert the battery into the charging station. The three con-
tacts of the battery must rest on the three contacts (a) of
the charging station.
3. First plug the barrel connector on the cable of the mains
adapter (13) into the socket (c) of the charging station and
then connect the mains adapter to the plug socket.
a
4. The green operating lamp (b) and the red charge control
b
lamp (d) will light up. The battery is being charged.
5. When only the green operating lamp is still lit, the battery
c
is fully charged.
23 EN