EDM Product 08790 Manuel D'instructions page 57

START-UP
Connecting the pipe or hose line
The device may be operated using either a hose line or a pipe. Ex
factory, the device is delivered
with a 1 ½" internal thread.Please observe the following information
regarding the water discharge:
▶ Please note that making use of the reducer (7) might decrease the
device performance. The reducer (7) should be shortened to the
used diameter so as not to decrease the device performance unne-
cessarily.
▶ Please note that the device cannot be moved as flexibly when
using a solid pipe.
▶ Please note that the maximum particle size is to be reduced in
proportion to the hose or pipe diameter.
▶ Please note that the conveying capacity declines with an increa-
sing length of the water discharge line.
HOSE LINE
If required, you can cut the reducer (7)
off at the desired diameter.
1. Screw the elbow (8) or adapter (9) onto the connection with 1 ½"
internal thread (6).
2. Screw the reducer (7) onto the elbow (8) or adapter (9). (see fig. 5)
fig. 5
Instruction manual Ref. 08790 / Ref. 08791
fig. 6
ES
PT
EN
FR