Mains Connection; Operation - Sanitas SIH 21 Mode D'emploi

• Connect the other end of the hose [8] to the hose
connector [6] on the nebuliser by lightly turning it.

Mains connection

Connect the unit only to the mains voltage listed on
the type plate.
• Insert the mains cable plug [1] into a suitable socket.
• Push the plug completely into the mains socket.
Note
• Ensure that there is a socket near to where the unit
will stand.
• Lay the mains cable in such a way that no one can
trip over it.
• To disconnect the nebuliser from the mains after use,
first switch off the device and then remove the plug
from the socket.

6. Operation

Caution
• For hygiene reasons, the atomiser [9] and the ac-
cessories must be cleaned after each treatment and
disinfected after the last treatment of the day.
• If several different medicines are to be inhaled in suc-
cession during therapeutic use, the atomiser [9] must
be rinsed under warm tap water after each use. For
information about this, see "Cleaning and disinfec-
tion" on page 15.
• Follow the instructions for changing the filter con-
tained in these instructions.
• Before each use, check that the hose connections
on the nebuliser [6] and the atomiser [9] are tight.
• Before use, check that the device is functioning cor-
rectly. To do this, switch on the nebuliser (including
the connected atomiser, but without any medication)
for a short time. If the atomiser [9] expels air, the
device is functioning correctly.
All manuals and user guides at all-guides.com
1. Inserting the nozzle attachment
• To open the atomiser [9], twist the upper section anti-
2. Filling the atomiser
• Pour an isotonic saline solution
• Use medication only on the advice
• If the required volume of medi-
3. Closing the atomiser
• To close the atomiser [9], twist the upper section
4. Connecting the accessories to the atomiser
• C
• Before commencing treatment, pull the atomiser
• Start the nebuliser using the on/off switch [3].
• A flow of spray from the atomiser indicates that the
5. Treatment
• Inhale the nebulised medicine deeply.
During treatment, hold the atomiser straight (verti-
cal), otherwise the atomisation does not work and
correct function cannot be guaranteed.
Essential oils, cough medicines, solutions designed
for gargling, and drops for application to the skin
or for use in steam baths are wholly unsuitable for
inhalation using a nebuliser. These substances are
often highly viscous and can impair the correct func-
tion of the device and hence affect the effectiveness
of its application in the long term.
In the case of oversensitivity of the bronchial
system, medicines containing essential oils can
sometimes cause acute bronchiospasm (a sudden,
14
clockwise against the medicine container [11]. Place
the nozzle attachment [10] in the medicine container
[11].
or the medicine directly into the
medicine container [11]. Do not
overfill! The maximum recom-
mended fill level is 6 ml !
of a physician, and check the ap-
propriate inhalation duration and
quantity for your needs.
cation is less than 2 ml, top up this quantity to at
least 4 ml using an isotonic saline solution. Viscous
medicines may also require dilution. Always follow
the instructions of your doctor.
clockwise against the medicine container [11]. En-
sure the parts are connected correctly.
onnect the required accessory part (mouthpiece
[12], adult mask [13] or child mask [14]) to the atom-
iser [9].
upwards out of its holder [7].
device is functioning properly.
Note
Important