dynatec PSG 45 Mode D'emploi page 16

GB
Max. volume
Max. viscosity
Max. pressure peaks
Voltage
Double insulation
Power consumption
Circular-section jet tip
* Measured in accordance with EN 60745-1
Materials to be processed
Paints and lacquers containing solvents, acrylic paints, water-soluble paints, glazes,
polishes, wood preservatives, disinfection agents, plant protective agents, impregnating
agents as well as oil and other watery liquids.
The following sprayed materials are not suitable for processing
Dispersion and latex paints, materials that contain highly abrasive components, glazes with
coarse components, paint removers and caustic solutions, silicate paints. The processing
these sprayed materials can result in increased wear or in corrosive damage in the area
of the pump that are not covered by the Dynatec guarantee.
Preparation of the sprayed material
In order to be processed with the spray gun, the paints may have to be diluted.
Information on dilution for spraying purposes is given in the following viscosity table
(paint viscosity).
Measuring the viscosity
Immerse the viscosity cup (Fig. 1) into the sprayed material until it flows over the edge.
Lift the viscosity cup and measure the time (in seconds) until the liquid strand breaks.
Compare the measured "flow time" with the viscosity table.
Sprayed material
Paints that can be diluted with solvents / primers
Water-soluble paints / primers
12
Technical Data
140 g/min Container contents
(flow time) 40 sec. Pump cylinder
100 bar Piston
230 V, 50 Hz Oscillation level:*
45 W Sound-pressure output:*
0,6 mm Weight
Handling table for viscosity
Uncertainty K:
Sound pressure level:*
Uncertainty K:
Uncertainty K:
Viscosity: Flow time in seconds
PSG 45
700 ml
Special steel
Special steel
Ø 4 mm
11,3 m/s
2
1.5 m/s²
87 dB (A)
4 dB
100 dB (A)
4 dB
1 kg
15 - 30
20 - 30