DeLonghi AN Serie Mode D'emploi page 7

4) Fit the wall flange 12 into the hole.
5) Screw the hose adaptor 14 to the hose's end 13 (fig. A).
6) Fit the air exhaust hose in the housing at the back of the
appliance as shown in figure A.
7) Screw the wall mounting accessory 15 into the hose 13
(fig. D) and fit it into the wall flange 12 as shown in fig. E.
D
E
When the hose 13 is not fitted, the hole can be closed with the
flange cap 12.
Note:
• As special tools are required for installation, we
suggest you have the appliance installed by specialized
personnel.
• Keep the air hoses as short and free of curves as possible
to avoid constrictions.
Air conditioning without installation
You can also set-up in a double-hung window:
1) Place the bracket in the window sill, extend the bracket
fully within the window frame, fix the bracket by using the
pin then lower the window onto the bracket. (Should the
window bracket be too large for the window. The plastic
can be cut with a saw by a qualified professional).
2) Fit the air exhaust hose in the housing at the back of the
appliance. Insert it as shown in fig. A.
3) Screw the window outlet 17 to the other end of the
exhaust hose (see fig. F).
F
4) Insert the window outlet end of the exhaust hose into the
2
Other set-up methods:
MAX100 cm
•
MAX 39 inches
MIN 35 cm
MIN 14 inches
•
6
slot of the window bracket (fig. G).
Thanks to the locking pins, it's possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust
hose (see fig. H).
If you have a casement window f ollow steps 2 & 3 and
place the window outlet outside the window to exhaust
the hot air (fig. I).
G
H
I