Vuly THUNDER PRO Manuel page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.0 Installation
STEP 9
Take your Frame Reinforcements and prop them over the Leaf
Spring hole at the centre of each Frame section, so that each
supports each Upper Frame Tube.
Insert Leaf Springs through the holes in the Frame Reinforcements
and into the Leaf Spring holes.
STEP 10
A.
Go around your trampoline, inserting and attaching the re-
maining Leaf Springs. Do so by connecting one Leaf Spring in
each frame section, before connecting the corresponding Leaf
Spring on the opposite side of the Jump Mat – until you have
attached every Leaf Spring.
Ensure that you slip the mat connectors through the net connector
holes as you do so.
B.
Twist Safety Rings onto every mat connector to fully secure the
Leaf Springs.
STEP 11
A.
Insert each Upper Net Pole and Lower Net Pole into either end
of each Middle Net Pole.
NOTE: The Lower Net Pole is reinforced at the bottom. The Middle
Net Pole has a single hole at the top. The Upper Net Pole has three
holes for the Shade Cover.
B.
Rest the completed Net Poles against the frame at each
STEP 12
Insert each Net Pole Plug into every Upper Net Pole.
Ensure that the materials are not twisted and that the
Upper Net Pole is facing outwards.
30 | Vuly Thunder Pro
A
B
B
A
5.0 Installation
STEP 13
A.
Lift a Net Pole, raising the Safety Net at the same time, and
insert it into the Joiner Pole.
B.
Repeat for each Net Pole until you have completely
erected the Safety Net.
REMEMBER: Ensure that the Safety Net is correctly
assembled. A properly installed Safety Net is crucial
to protect against injuries!
STEP 14
FindthefirstJoinerPoletotheleftoftheentrance.
Hook the Skirt clip around the Leaf Spring on the left
side of that Joiner Pole.
STEP 15
A.
Pull the Skirt clockwise around the trampoline, feeding it
through the inside of the Net Poles as you go.
B.
Move the Skirt hook from the Leaf Spring to the Skirt
hook loop, once you are back at the start.
C.
Zip the Skirt together, and fasten the Velcro behind
each Joiner Pole.
STEP 16
Fasten the Velcro straps together around the Lower Frame Tube at
the left and right of each Joiner Pole.
WARNING: Make sure that all push buttons are locked and secured
before using your trampoline.
Bouncing on a trampoline with push buttons that are not locked will
cause damage and injury!
CONGRATULATIONS !
You have assembled your VULY Thunder trampoline!
A
C
Vuly Thunder Pro | 31

Publicité

Table des Matières
loading

Produits Connexes pour Vuly THUNDER PRO

Ce manuel est également adapté pour:

3115305

Table des Matières