Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Do not overtighten the compression nut.
• Using Copper Tubing
- Slip the compression nut and ferrule on copper
tubing as shown.
• Using Plastic Tubing
- Insert the molded end(Bulb) of the plastic
tubing into the compression fitting.
Do not use without the molded end(Bulb)
of the plastic tubing.
CAUTION
3. Tighten the compression nut onto the
compression fitting.
4. Turn water on and check for any leakage.
• Water line must be connected to
drinkable water only.
• When pushing the Refrigerator back,
make sure you don't roll over the power
cord or water line (Icemaker supply line).
ICE MAKER OPERATION
The ice maker will produce 8 cubes per cycle
- approximately 100~130 cubes in a 24-hour
period, depending on freezer compartment
temperature, room temperature, number of door
openings and other use conditions.
Throw away the first few batches of ice to allow
the water line to clear.
Be sure nothing interferes with the sweep of the
feeler arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
After the icemaker has been turned on again,
there will be a time delay before the icemaker
resumes operation.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale and shrink.
So if you don't want to make ice, press the Ice Off
button.
Test Button
DA68-02601N-00.indb 24
English - 24
2017. 1. 23.
3:08
Publicité
Table des Matières
