Setting The Timer - Melitta THERMAL CAFE ME8DSB Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Setting the Timer

1. While holding the PROGRAM button down, press and hold the
HOUR button until the hour display begins to change. The
coffee cup icon on the left of the display will flash to indicate you
are programming the timer. Continue to press the HOUR button
until the correct hour is displayed for the brew time you would
like to set, noting that PM is indicated on the left of the display.
2. While holding down the PROGRAM button, press the MIN
button in the same way until the desired brew time is shown.
3. After the brew time is set, press PROGRAM again to return the
display to time of day.
4. Pressing the PROGRAM button toggles the timer on and off.
The coffee cup icon indicates when the timer is on.
To Start Brewing
Coffee Immediately
For optimal holding temperature, rinse the inside of thermal
carafe with warm water before brewing; empty and make sure
carafe lid is properly secured onto carafe. Place carafe securely
onto coff e e m a k e r.
Press the ON/OFF button. The ON LED will illuminate as the
Coffee Maker begins brewing the coffee. Once the brewing cycle
is complete the Coffee Maker will turn OFF automatically.
To Start Brewing Coffee
At The Programmed Time
At the programmed time, the Coffee Maker will turn itself on
automatically. The ON light will turn on as the Coffee Maker begins
brewing and coffee will begin flowing into the thermal carafe.
Once the brewing cycle is complete the Coffee Maker will turn
OFF automatically.
NOTE: The amount of coffee in the carafe may be slightly less
than the amount of water placed in the water reservoir, since some
of the water is absorbed by the coffee grounds.
8

Publicité

Table des Matières
loading

Table des Matières