Installing/Removing Shoulder Belt Guide - Harmony YOUTH BOOSTER ELITE Manuel D'instructions

4. Buckle vehicle seat belt into place. Ensure the buckle
is secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.
!
Any straps holding the restraint to the vehicle should be
tight, any straps restraining the child should be adjusted
to the child's body, and the straps should not be twisted.
! NEVER USE A VEHICLE LAP-ONLY BELT WHEN USING
THIS BOOSTER SEAT.
! WARNING: To avoid possible entanglement hazard,
see "Entanglement with vehicle seat belt".
! THE VEHICLE'S SHOULDER BELT MUST LIE ACROSS THE
CHILD'S SHOULDER AND LAY ACROSS THE CHEST – NOT
THE FACE OR NECK. If the belt does not lie properly across
the child's shoulder and chest, the RED shoulder belt
guide ("Parts list - C") MUST be used to ensure proper
placement (see "Using shoulder belt guide").

INSTALLING/REMOVING SHOULDER BELT GUIDE

! OPENING OF RED BELT GUIDE CLIP MUST FACE FORWARD.
TO INSTALL:
1. Insert loop end of strap
around bar on rear of seat
❶ on side NEAREST to
the vehicle retractor.
2. Pass the red clip and strap
through the loop end ❷ and pull strap
tight ❸.
It is recommended to store the unused
shoulder belt guide along with any other
parts from the booster seat for future use.
19
❶
❷