LEXIBOOK Meteoclock PURE SM1670 Mode D'emploi page 19

WARNING: Mal-function or loss of memory may be caused by strong frequency interference or
electrostatic discharge. Should any abnormal function occur, press the RESET button or remove
the batteries and insert them again.
Weather forecast symbols and barometric pressure settings
1. When you install or change the unit's batteries (or if you press and hold the "REL/ABS
WEATHER" key), the weather forecast symbol flashes on the LCD screen to indicate that you
need to set the current weather status.
2. Enter the current weather using the "+" and "–" keys to choose among the 5 weather forecast
symbols available.
Sunny Slightly cloudy
Note : The
and the outdoor temperature is under 0°C.
3. Press the "REL/ABS WEATHER" key to confirm the setting. The barometric pressure digits will
start flashing.
4. Using the "+" and "–" keys to indicate the barometric pressure at sea level then press the
"REL/ABS WEATHER" key to confirm the setting.
Note: Please refer to your local weather station to get information about the barometric pressure at
your location.
5. If you need to change the settings, press and hold the "REL/ABS WEATHER" key until the
weather forecast icon start flashing on the LCD screen then repeat 2, 3 and 4 above.
Note:
• If you do not set the current weather status or if the weather symbol selected is incorrect, the
unit's weather forecast may not be accurate.
• If the weather station is moved to another location significantly higher or lower than its initial
standing point (e.g from ground floor to 1st floor of a house), the current weather status must be
changed as well.
Cloudy
icon will be displayed when the weather forecast is "Rainy" or "Cloudburst"
Rainy Cloudburst
19