LEXIBOOK Meteoclock PURE SM1670 Mode D'emploi page 18

Remote sensor battery installation
1. Use a screwdriver to open the battery compartment located at the back of the
remote sensor.
2. Insert 2 x 1.5V
indicated inside the compartment and as per the diagram shown opposite.
3. Close the battery compartment and tighten the screw.
Note: When the remote sensor's batteries are low, the "low battery" indicator
displayed on the LCD screen of the sensor.
Main unit battery installation
1. Open the battery compartment located at the back of the main unit.
2. Insert 3 x 1.5V
the polarity indicated at the bottom of the battery compartment, and
as per the diagram shown opposite.
3. Close the battery compartment.
Note:
• When the main unit and remote sensor's batteries are low, the "low battery" indicator
displayed on the LCD screen of the main unit.
• When the main unit's LCD display becomes dim, it indicates that the batteries are low and need
to be changed.
• If the sensor is exposed to very low temperatures for an extended period of time, the batteries
may lose power which may cause the transmission range to be limited. High temperatures also
reduce the battery performance.
Non-rechargeable batteries are not to be recharged. Remove the storage batteries before
recharging. Recharge storage batteries under adult supervision. Do not mix different types of
battery and storage battery, or new and old batteries or storage batteries. Insert batteries and
storage batteries according to the polarity. Remove used storage batteries from product. Do not
short-circuit the battery or storage battery terminals. Keep batteries away from fire. If the product
remains unused for an extended period, remove batteries.
18
SETTINGS
LR03/AAA type batteries (not included) according to the polarity
LR6/AA type batteries (not included) observing
is
is