Mono Blend Input Jack; Bluetooth™ Control; Protection; Stand Mounting Adapter - YORKVILLE elite ES Serie Manuel De L'utilisateur

Tip: As well as accommodating full range enclosures, the Link jacks allow many ES Series Powered
Subwoofers to be connected in a string (parallel). There is no practical limit to the number of ES Series
Powered Subwoofers that may be connected together.
WARNING: Do not plug in two speaker level sources to a single ES Series Powered Subwoofer

6. Mono Blend Input Jack

The Mono Blend Input jack enables you to connect a secondary line level signal to the system without need-
ing to externally sum two signals (e.g. Left and Right). This is helpful when you are adding a single ES Series
Powered Subwoofer to a stereo system. By using this input for your secondary signal, it is blended internally
with the Link input but isolated to prevent interaction of those signals.
7. Bluetooth™ Control
This control enables or disables the Bluetooth™ connection between a tablet or a smart phone using the
Yorkville App. Pressing the Bluetooth™ button for more than 4 seconds resets the ES-Series powered sub-
woofer to factory settings.
Note: The Bluetooth functionality on this product is intended for control only. It does not allow for
Bluetooth audio connection

8. Protection

The ES Series Powered Subwoofers have a DSP-based circuit to prevent clipping, over power and over excur-
sion. At high levels the limiter will limit the gain of the ES Series Powered Subwoofer and hence if the user
attempts to set the subwoofer level control at a high level, the resulting setting will be overridden by the internal
protection. The level control should be set while operating at low levels (under 10 watts). This is accomplished
by turning the master volume of the signal going to the subwoofer down to allow the balancing and setting of
the bass along with the full range speaker top in use. If the level control is set too high due to setting it at high
operating levels the input circuit will clip and the dynamics of the bass will be lost. The Red Clip indicator will
signify when this occurs. This can happen without audible distortion since the filters and limiters will suppress
the distortion.
Note: At high power levels, when the limiter is operating, increasing the Subwoofer's Level Control will NOT
increase the output.. Do NOT continue to increase this setting while operating at high levels.

9. Stand Mounting Adapter

The ES Series Powered Subwoofers come equipped with a built-in stand mounting adapter that can be used
with Yorkville SW-Teletube accessory to support élite powered top cabinets.
WARNING: ES Series Powered Subwoofers MUST be on a flat, level surface to support the cabinet safely.
Do not use larger than the recommended top cabinets!
3