Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
*
POWER
LEVEL
ACTIVITY
CLIP
LIMIT
X-MAX
TEMP
MONO BLEND INPUT
Line Level Sources Only!
A '12 o'clock' setting on the ES Series Powered Subwoofer's Level control is the correct starting point when
setting up a sound system. The '12 o'clock' mark refers to the setting that will give full power when the line input
is used and the input signal is at a level of +4 dBV.
Note: At high output levels, this control may be overridden by the internal limiter.
3. Mode Control
There are three different modes of the DSP signal processing that can be used, Punch, Smooth and
Deep. The switch settings affect the compromises between sound character and loudness when the loud-
speaker is driven into limiting. The switch also makes some changes to the equalization.
Punch Mode will process the sound so it is perceived as a punchier sound, giving less power into deep
bass and more into the upper bass.
Smooth Mode will keep the original signal character with no preference for deep or upper bass.
Deep Mode will process the signal to provide a deeper sound, giving more power into deep bass while keeping
the upper bass similar to the Smooth Mode.
4. Hi Frequency Rolloff
The HF Rolloff Frequency control sets the upper bass frequency at which the ES Series Powered Subwoofer
rolls off, providing part of the 'crossover' function. Ideally the ES Series Powered Subwoofer would be used
with an élite powered top cabinet with both cabinets set at 100 Hz (élite enclosures have the subwoofer mode
crossover setting at 100 Hz).
5. Input / Output LINK Jacks
The Link jacks are designed to make it easy to hook up your ES Series Powered Subwoofer to any audio
system with a minimum of hassles. Since all of the Link jacks are connected in parallel, you can use them to
daisy-chain other ES Series Powered Subwoofers or full-range enclosures. For normal operation, connect the
ES Series Powered Subwoofer just like an ordinary speaker along with the full range enclosures.
Note: the Mono Blend Input is designed for Line Level signals only!
Line Level
If the ES Series Powered Subwoofer is receiving the signal from a non-powered mixer, a line level signal
processor (as in an equalizer) or another line-level source, set the input switch to Line.
Speaker Level
Set the Input Level switch to Speaker if the signal is coming directly from a power amplifier, 'powered' mixer,
or other powered source.
Note: The ES Series Powered Subwoofer may be plugged in before or after the full range enclosure.
The ES Series Powered Subwoofer does not alter the signal to the daisy chained enclosures and
will not draw any power from the host amplifier/processor driving them. Also, note that an external
crossover is not necessary when using the ES Series Powered Subwoofer.
SUB
*
MODE
1
0
2
1.
Punchy
3
2.
Smooth
3.
Deep
12
*
dB
Controls may not reflect
the applied settings if Bluetooth
remote function is enabled.
INPUT
MODE
SPKR
LINE
NOTE: THE YORKVILLE APP IS NEEDED TO CONTROL FUNCTIONS
THROUGH BLUETOOTH
AND IS NOT FOR STREAMING AUDIO!
TM
*
HI FREQ.
WIRELESS
ROLLOFF
CONTROL
80
Bluetooth
TM
90
SMART
LED Flashing:
Ready to Connect
110
LED On:
Connected
120
Hz
130
150
Enable / Disable
Hold 4 sec. to reset
Recommended for
élite speaker cabinets.
INPUT
OUTPUT
2
Publicité
Table des Matières
