JANE WOODDY Mode D'emploi page 9

FIT THE SEAT
Fit the 4 plastic supports underneath the seat into the 4 large holes in the stool.
Once the 4 supports have been slotted into place, hold the seat with both hands and push it firmly backwards
until it clicks into place.
Check that the locking button is activated.
1 FIT
•Check that the pin is visible and activated and the seat is firmly locked in place
•Fit and make sure the safety lock is ALWAYS tightly fastened, check this regularly.
OK
FIT THE TRAY
Open the 2 catches found on the bottom of the tray and insert it into the 2 side supports of the seat, release the
catches in the required position (2 positions).
FIT THE SAFETY HARNESS
•First insert the plastic anchor of the shoulder strap into the side clasp of the harness, then insert these 2 parts
together into the central clasp until you hear it click into place.
•
•To fit the harness to the baby slide the strap through the rectangular clasps.
•
CLOSE
CLICK!
2
SLOT
SAFETY
LOCK
"CLICK"
2
1
1º
2º
3
PUSH
"CLICK"
2
1
OPEN
CLICK!
PUSH
LOCK (4 PINS
4
PUSHED BACK)
"CLICK"
OK
TRAY INSERT
PUSH