JANE WOODDY Mode D'emploi page 8

Fit the 2 rear legs (C and D)
Insert each leg into the rear supports of the seat, press the unlocking button and press the legs inside until the
button slots into place (you will hear the safety click when it is in place).
Fit the 2 end covers with the metal bar on the end of each leg, press the unlocking button and press them on as
far as they will go (they will click into place).
"CLICK"
C-D C-D
"CLICK"
D
"CLICK"
C
"Click"
"Click"
C D
Fit the side supports
Position each plastic side support with the smooth part facing outwards, fit and tighten the 2 screws with the
Allen key supplied, regularly check that the screws remain tightly fastened.
OK
L
OK
Fit the footrest
Position the footrest between the 2 front legs and on each side slot the 2 lateral guides of the plastic support
into the inner wooden runners on the leg.
Underneath the footrest on each side fit and tighten the plastic side screws A and B.
Set the other 2 screws that support the footrest underneath to position 1.
4 4
1 1
A B