Mains Operation; Power Supply - NUK e-Motion Mode D'emploi

5.3 Sterilising
Before sterilising, clean as described in section
"5.2 Cleaning (Figure Πin reverse order)".
The motor unit and adapter (parts
Important!
- ) should never be sterilised as this may
11 19
damage the electrics.
• Use a NUK Steam Steriliser, observing the
relevant operating instructions, or sterilise
the parts in boiling water for 5 minutes.
1. Insert the valve into the breast shield
1
with the knob pointing upwards.
2. Position the motor unit
shield 2 .
3. Screw the connection ring
onto the motor unit

7.1 Mains operation

For mains operation
adapter, model KK 07-045-0800.
1. Open the battery compartment by the catch
lock .
15
2. Insert the plug
11
adapter 18 into the socket
in the battery compartment.
3. Close the battery compartment again.
Push both the "feet" on the
lid into the relevant recess
on the motor unit and shut
the lid, ensuring the catch
lock 15 engages with click.
Note: The device should not
be operated without the
battery compartment lid.
4. Fit the interchangeable plug attachment
suitable for your power supply to the adapter.
All manuals and user guides at all-guides.com
6. Assembly
2
on the breast
12
3 from below
.
12

7. Power Supply

only use the enclosed
on the
19
Ensure there is sufficient water in the sauce-
pan to avoid damage.
Parts should not be sterilised in a
Caution!
microwave, as this can result in damage to the
material.
Important! Ensure that the accessories and
parts have completely cooled and dried before
using again.
Œ
(Figure )
4. Insert the lip valve
assembled breast shield
5. Screw together the assembled motor unit
and the bottle 5 .

(Figure )
You can find out which plug is suitable for
your country from the below section.
5. Plug the mains plug
21
from below into the
4
.
2
12
into a wall socket.
18