Publicité
Les langues disponibles
Les langues disponibles
Charging
Press the MODE button once briefly. You will hear a short beep in confirmation, and the red
FAST CHARGING LED will glow. The battery is now charged at the set current, and the
screen displays the charged-in capacity. The charge process is terminated by the automa-
tic Delta Peak circuit when the pack is fully charged.
Discharging
Hold the MODE button pressed in for about two seconds. You will hear two short beeps in
confirmation, and the yellow DISCHARGING LED will glow. The battery is discharged at
around 1 A (voltage-dependent), and the screen displays the discharged capacity. The
discharge process is terminated at a battery voltage of around 0.8 V per cell.
Discharge-before-Charge
Press the MODE button twice briefly. You will hear three short beeps in confirmation, and
the charger carries out a discharge process followed by a charge process. The screen dis-
plays the charged-in or discharged capacity according to the active function.
The DISCHARGING LED or the CHARGING LED lights up to indicate which phase is in
progress at any time.
Cyclic Discharge-before-Charge
The cycle function can be used to rejuvenate older batteries once the pack has been balan-
ced; we recommend three to max. five cycles.
Press the MODE button twice, holding it pressed in for two seconds the second time. You
will hear four short beeps, and the charger embarks on an infinite number of discharge-
before-charge cycles. The screen displays the charged-in or discharged capacity according
to the active function.
The functions are either terminated automatically or by the operator pressing the MODE
button, in which case you will hear two long beeps in confirmation.
If the charger switches off automatically you will hear one beep every ten seconds.
In all cases the charger reverts to trickle charge mode after termination, the green LED flas-
hes and the screen shows the stored charged-in or discharged capacity value at the time
of the termination. This capacity value is erased when you either connect a battery pack, or
you switch from Charge to Discharge or vice versa.
Fault-finding
-
SLOW CHARGING LED flashes, charger does not respond to MODE button. Battery
connected with reverse polarity, or short-circuit present at charge output.
-
SLOW CHARGING LED does not flash: interruption in battery lead, or fuse blown.
All manuals and user guides at all-guides.com
Operating instructions
POWER PEAK 1 Plus
9
Order No.
8424
Publicité
