Publicité
Les langues disponibles
Les langues disponibles
Charger controls
LCD screen
Power supply
Charge current knob
Using the charger
-
Connect the crocodile clips to a 12 V lead-acid battery or a suitable mains PSU; take
great care over correct polarity (red = positive / black = negative); see section entitled
"Mains PSU".
-
The LCD screen will show "0000", and the LEDs will remain off.
-
Connect the charge leads to the charge output sockets with correct polarity (red = posi-
tive / black = negative).
The charger features the following functions: Charge, Discharge, Discharge-before-Charge
and cyclic Discharge-before-Charge. The following steps are required to activate these fun-
ctions:
-
Select the battery type using the NICD / NIMH slide switch.
-
Connect the battery pack to the charge lead, taking great care over correct polarity. The
unit emits a beep, and the green SLOW CHARGING LED flashes to indicate that trick-
le charging is taking place.
-
Set the charge current on the CHAR CURRENT KNOB. Note that 4-cell and 5-cell
packs must be charged at no more than 1.5 A. Moreover the maximum charge rate
for 4-cell and 5-cell NIMH batteries must not exceed 1C, e.g. 1.0 A for a battery of
1000 mAh capacity.
All manuals and user guides at all-guides.com
Operating instructions
POWER PEAK 1 Plus
8
DISCHARGING-LED
FAST-CHARGING-LED
SLOW-CHARGING-LED
Fuse
Charge output
Order No.
8424
MODE button
NICD/NIMH
select switch
Publicité
