Frequently Asked Questions - Marmitek TV ANYWHERE Guide Utilisateur

Masquer les pouces Voir aussi pour TV ANYWHERE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37

6. FREQuENTlY ASKED QuESTIoNS

The system does not work properly
Attention: The power adapters for the transmitter and receiver are different. You need
to connect the small power adapter to the receiver. The large power adapter needs to be
connected to the transmitter.
Poor picture quality on all TV channels
1. D isturbances in the signal can sometimes affect the transmission quality. Move the TV
Anywhere transmitter or receiver a few centimeters to solve the problem.
2. C hange the channel settings (A .. D) for both the transmitter and the receiver. The channel
setting on the transmitter must match the setting on the receiver (e.g. both set to B).
Poor picture quality on some of the TV channels
1. C heck the antenna connection of the TV Anywhere transmitter. You can check the
signal on the transmitter side by directly connecting a TV to the antenna connection. It is
especially important to check your antenna system, as high frequency channels contain
more noise that lower frequency channels.
2. I f the TV channel found is not tuned properly, use the FINE TUNE+ and FINE TUNE- buttons
to fine tune the TV channel. Press COPY followed by PASTE to store the new settings.
The infrared extender does not work
1. I s the infrared extension cable connected to the TV Anywhere transmitter? Are the
infrared eyes attached to your equipment at the right position? Try to experiment with
their location if you are not convinced of the right position on your device.
2. I f you are using wireless headphones, wireless speakers or other equipment using
433.92MHz transmission, this could affect the range of the infrared extender function
dramatically. Switch these devices off to improve the range.
The remote won't control your A/V equipment or doesn't work at all
1. U se manual controls or the original remote control to confirm the equipment is working
properly.
2. Make sure you press the device button for the device you want to control.
3. Re-enter the code for your A/V device form the code list.
4. Try searching for codes by using the Manual or Automatic code search.
5 Check the polarity of the batteries.
6. Replace the batteries.
The remote won't work with the TV Anywhere
1. T he code for the remote control does not match the code set up for the TV Anywhere
system.
2. T o operate the TV Anywhere with the remote provided, you need to point it at the TV
Anywhere receiver.
1
All manuals and user guides at all-guides.com
© MARMITEK

Publicité

Table des Matières
loading

Table des Matières