Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
58
DSR1024 Switch Installer/User Guide
To configure a DSRIQ-SRL module:
1. Press
Ctrl-F8
2. Select a parameter to change. You can navigate the Configuration Screen using the
and
Down Arrow
3. Modify the selected value using the
4. Repeat steps 2 and 3 to modify additional values.
5. Press
Enter
-or-
Press
Escape
Creating a DSRIQ-SRL module macro
You can access the Macro Configuration screen by pressing the
Terminal Applications menu's Configuration screen is open. You can configure the DSRIQ-SRL
module with up to 10 macros. Each macro can be up to 128 characters in length.
To create a macro:
1. Select the DSRIQ-SRL module you wish to configure and press
Terminal Applications menu's Configuration screen.
2. When the Terminal Applications menu appears, press
screen. The Macro Configuration screen shows the 10 available macros and the associated key
sequences, if any, for each.
3. Using the
Up Arrow
the listed keystroke sequence. Type the new macro keystroke sequence over the default. Any
combination of
keystroke sequence that will activate the new macro, press the
4. On the line below the macro keystroke sequence you just entered, type the keystroke sequence
that you wish the macro to perform.
5. Repeat steps 3 and 4 to configure additional macros.
6. When finished, press
Using History mode
You can use History mode to examine the contents of the history buffer, which contains the events
that have occurred. The DSRIQ-SRL module maintains a buffer containing 240 lines minimum, or
10 screens, of output. When the history buffer is full, it will add new lines at the bottom of the
buffer and delete the oldest lines at the top of the buffer.
NOTE: The Config Key Sequence, On-Line Key Sequence and Clear History Key Sequence used in the
following procedure are the default values. You can change these key combinations by using the Terminal
Applications menu.
All manuals and user guides at all-guides.com
to open the Configuration Screen.
keys.
to save your changes and exit the Configuration Screen.
to exit the Configuration Screen without saving the changes.
and
Down Arrow
or
and a single key may be used. When you have finished entering the
Ctrl
Alt
to return to the previous screen.
Enter
and
Left Arrow
Right Arrow
Page Down
Page Down
keys, scroll to an available macro number and highlight
Up Arrow
keys.
key while the
to activate the
Ctrl-F8
to view the Macro Configuration
key.
Down Arrow
Publicité
Table des Matières
