Omcan Santos 50 Manuel D'instructions page 5

5. Neither a hose nor a pressure hose should be used for cleaning.
6. Do not use abrasive sponge for cleaning the basket.
7. The appliance must not be used on any surface which has a slope of more than 10° relative to horizontal.
The machine's 4 feet must always be resting on that surface.
8. Never plunge the base in water or any other liquid for reasons of protection against risks of electrocution.
9. The appliance must be unplugged before any intervention on it: cleaning, general care, maintenance.
10. Use of spare parts other than certified original parts is prohibited.
11. Do not use the appliance if the power supply cord is damaged. It must be replaced by either a Omcan
approved dealer or a person with similar qualifications to avoid any danger.
12. Never connect several appliances to the same power socket.
13. Never use the appliance outdoors.
14. Never place the appliance close to or on a source of heat.
15. This appliance is a professional machine designed exclusively for professional use. It is not designed for
household use.
16. This appliance is not designed for use by people (including children) whose physical, sensorial or mental
capacities are impaired or by people with no experience or knowledge, unless they have been supervised
or given training in the use of the appliance beforehand by a person responsible for their safety. Supervise
children to ensure they do not play with the appliance.
WARNING
During preparation, the level in the pulp container (6) should be monitored to prevent the cover pulp outlet
(2) from clogging. Such clogging could result in an imbalance in the basket assembly (5) and thus a risk of
damaging the machine. The quantity of products to be processed before reaching the container (6) maximum
filling varies depending on the products being processed. As an indication it corresponds to approximately 10
kilograms of apples and approximately 6 kilograms of carrots. If during preparation an imbalance should occur
well before the pulp container is full, it is sometimes appropriate to continue adding food for the imbalance to
be cleared. If however it should persist, the machine should be stopped and the basket assembly (5) cleaned.
Certain products have the ability to clog or block the sieve holes, in which case the basket assembly (5) will
need to be cleaned more frequently.
COVER AND BOWL PRESENCE SAFETY DEVICE:
For the juice extractor to be able to start, the cover (2) and the bowl (4) must be centered in position on the
bowl centering device (7) and held by the clamping handle (1). Putting the clamping handle in the vertical
position (up) without the bowl or without the cover means that the machine cannot be started.
MOTOR OVERLOAD SAFETY FEATURE:
Should the motor become blocked (foreign body, object that is too hard, too much pressure with the fruit
plunger on the products being processed), the On / Off switch (11) automatically trips to the 0 position. Correct
the problem and press the On / Off switch (11) (position 1).
If the problem persists, switch off the power supply to the machine (unplug the cord from the mains socket
(10)) and call Omcan or a approved dealer.
Safety and Warranty
5