Axis 1650 Manuel D'instructions page 13

AXIS 1650 Set-up Instructions
Connect to Scanners
These sections describe how to scan via an AXIS 1650 using AXIS ScanClient. For general
information on scanning, see your Canon device manual. The examples in this section show
Windows XP and a Canon MF3110 with MF Toolbox.
AXIS ScanClient will open a channel between your computer and the scanner. The channel
will be open for a configurable amount of time to give you time to walk to the scanner and
place the object to be scanned on the flatbed. During this time you have exclusive rights to
the scanner.
Connect to the Scanner
AXIS ScanClient
1. Start
scanning devices. Mark the one you would like to use by clicking on it in the list (you
can also select a scanner by entering its IP address). Click [Connect].
2. If the scanner is busy AXIS ScanClient will
show who is using it, otherwise you will be
connected, as indicated on the message line.
3. Click [Help] to get information on how to
connect and disconnect.
Prepare your Computer (first time only)
1. Connect to the scanner with
Start | Settings | Control
2. Go to
Scanners and
3. Click on
(Start | AXIS ScanClient). The client will search the network for
AXIS ScanClient.
Panel.
Cameras.
Page 13