Declaration Of Conformity - Watlow RMA EZ-ZONE RM Guide De L'utilisateur

EZ Zone Series RM
WATLOW
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following Series RM (Rail Mount) products:
Model Numbers:
Classification:
Voltage and Frequency:
Power Consumption:
Environmental Rating:
Meet the essential requirements of the following European Union Directives by using the relevant standards show
below to indicate compliance.
EN 61326-1 2006
EN 61000-4-2 1996
EN 61000-4-3 2006
EN 61000-4-4 2004
EN 61000-4-5 2006
EN 61000-4-6 1996
EN 61000-4-11 2004
EN 61000-3-2 2005
2005
EN 61000-3-3 2
SEMI F47 2000
2 NOTE 1: To comply with flicker requirements cycle time may need to be up to 160 seconds if load
current is at 15A, or the maximum source impedance needs to be < 0.13. Control power input of RM
models comply with 61000-3-3 requirements.
EN 61010-1 2001
Per 2002/96/EC W.E.E.E Directive
Raymond D. Feller III
Name of Authorized Representative
General Manager
Title of Authorized Representative
Module RMA Watl ow EZ- Z ONE

Declaration of Conformity

RM followed by additional letters or numbers describing use of up to four module
options of various inputs and outputs or communications.
Temperature control, Installation Category II, Pollution degree 2
SELV 24 to 28 V ac 50/60 Hz or dc
RMA models 4 Watts, any other RM model 7 Watts
IP20
2004/108/EC Electromagnetic Compatibility Directive
Electrical equipment for measurement, control and laboratory
use – EMC requirements, Industrial Immunity, Class A
Emissions (Not for use in a Class B environment without
additional filtering).
A1, A2, 2001 Electrostatic Discharge Immunity
Radiated Field Immunity
Electrical Fast-Transient / Burst Immunity
Surge Immunity
A1, A2, A3, 2005 Conducted Immunity
Voltage Dips, Short Interruptions and Voltage Variations Immunity
Harmonic Current Emissions
Voltage Fluctuations and Flicker
Specification for Semiconductor Sag Immunity Figure R1-1
2006/95/EC Low-Voltage Directive
Safety Requirements of electrical equipment for measurement,
control and laboratory use. Part 1: General requirements
Compliant with 2002/95/EC RoHS Directive
Winona, Minnesota, USA
Place of Issue
Signature of Authorized Representative
®
ISO 9001
an
Please Recycle Properly
7 6
• •
approved facility since 1996.
March 2010
Date of Issue
C h ap itr e 8 An ne x e