Using Your Steam Generator - TEFAL EASYCORD PRESSING Notice D'emploi

ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or recycled.
Take it to a local civic waste collection point.
3. PREPARING YOUR STEAM GENERATOR
1. Place your steam generator on a flat, stable, heat-resistant surface.
2. Check that your appliance is disconnected and cold.
3. Unscrew the boiler cap (3).
4. Using a water jug, fill with maximum 1 litre of water.
5. Fill the boiler (4), taking care that the water does not spill over (Figure A).
If this occurs, remove the excess water.
6. Replace the boiler cap (3), screwing on tightly.
Type of water to use ?
Your steam generator has been designed to operate using untreated tap water.
If your water is very hard, mix it 50 % untreated tap water with 50 % distilled or demineralised water.
Types of water not to use ?
Heat concentrates the elements contained in water during evaporation. The types of water listed below may
contain organic waste, mineral or chemical elements that can cause spitting, brown staining or premature wear
of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries, air
conditioners, rain water, boiled, filtered or bottled water. These types of water should not be used in your TEFAL
iron. Also only use distilled or demineralised water as advised above.

4. USING YOUR STEAM GENERATOR

1. Connect your generator to an earthed socket.
2. Press the On/Off switch (5).
The steam indicator (6) turns on and the boiler (4) heats up.
When the indicator (6) goes out (after about 8 minutes), steam is ready .
During ironing the iron's thermostat light (9) and the steam indicator (6) will go on and off according
to the temperature control.
B :
E CAREFUL
• The first time the appliance is used, there may be some fumes and smell but this is not
harmful.They will not affect use and will disappear rapidly.
All manuals and user guides at all-guides.com
ENG