Settings; 7�1 The Sensor Is To Switch When The Object Is Detected; Io-Link; 8�1 General Information - Autosen AL002 Notice D'utilisation

7 Settings

All manuals and user guides at all-guides.com
7.1 The sensor is to switch when the object is detected
► Position the object�
► Press [+] to increase the range�
> The set distance value is shown flashing in the display�
> The yellow LED lights when the object is detected�
► Press [-] to decrease the range�
> The set distance value is shown flashing in the display�
> During operation, the currently detected distance value is shown in the display�

8 IO-Link

8.1 General information
This unit has an IO-Link communication interface which requires an IO-Link-
capable module (IO-Link master) for operation�
The IO-Link interface enables direct access to the sensor values and parameters
and provides the possibility to set the parameters of the unit during operation�
In addition communication is possible via a point-to-point connection with a USB
adapter cable�
You will find more detailed information about IO-Link at www�autosen�com�
Device-specific information
You will find the IODDs necessary for the configuration of the IO-Link unit and
detailed information about sensor values, diagnostic information and parameters
at www�autosen�com�
Parameter setting tools
You will find all necessary information about the required IO-Link hardware and
software at www�autosen�com�
UK
15