Laney LIONHEART L20H Mode D'emploi page 7

L20H FEATURES
15 16
14-
POWER INLET SOCKET: Connect to your power source. Make sure the specified voltage
is correct for your country!
15 -
POWER FUSE: This drawer contains the main safety fuse for the unit. The fuse protects
the AC power to the amplifier. USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS
SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the same size and
rating is installed and it in turn blows, the amplifier has suffered a malfunction internally
and needs immediate service from a qualified technician. DO NOT TRY USING A FUSE OF
HIGHER RATING. Using a fuse that is too large in current rating may cause serious,
irreparable damage to the amplifier and presents a serious fire hazard. The mains fuse
ratings are detailed in the specs section at the rear of this manual.
POWER: Main power switch for unit.
16 -
HT FUSE: This fuse protects the DC power to the tubes within the amplifier. USE ONLY
17 -
THE CORRECT SIZE AND RATING FUSE AS SPECIFIED ON THE PANEL. If a fuse blows
or fails and a replacement of the same size and rating is installed and it in turn blows, the
amplifier has suffered a malfunction, at this point check the output tubes and replace faulty
ones if required. Should tubes not be the problem the amplifier should be checked out by
a qualified technician. Do not try using a fuse of greater value. Using a fuse that is too
large in current rating may cause serious, irreparable damage to the amplifier. Fuses are
designed to protect, do not take chances.
18 - EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mis-
matched impedance will reduce the amplifiers performance and in some cases may cause
damage to your amplifier.
7
17
L20H USER MANUAL - EN
18
www.laney.co.uk