Care Recommendations - Sub-Zero UC-24BG Mode D'emploi

CARE RECOMMENDATIONS

Cleaning
INTERIOR CLEANING
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water and baking soda. Rinse and
dry thoroughly. Avoid getting water on lights and control
panel.
CAUTION
Do not use vinegar, rubbing alcohol or other alcohol-
based cleaners on any interior surface.
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly wipe
surface with a water-dampened microfiber cloth followed by
a dry polishing chamois. Always follow the grain of stainless
steel.
CONDENSER CLEANING
CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
The condenser is located behind the kickplate. To access,
remove the kickplate. Use a soft bristle brush and vacuum
to remove dust and lint from the condenser. Clean the
condenser every three to six months. Refer to the illustration
below.
To avoid damaging condenser fins,
IMPORTANT NOTE:
vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure or damage.
VACATIONS
For extended vacations, turn power off at the control panel.
Empty the unit and block the door open slightly to let fresh
air in and keep interior dry.
CONDENSER
Condenser location.
|
subzero.com 7