Specific Safety Rules And/Or Symbols; Charging Time - Toparc BT-10323001-15 Mode D'emploi

Kit de secours du hautparleur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Translation of the original instructions

reassembling may result in a risk of electric shock or fire.

Additional Safety Rules for Charger & Battery Pack

1. Do not charge battery pack when temperature is below 10°C (50°F) or above 40°C (104°F).

2. Do not attempt to use a set-up transformer, an engine generator or DC power receptacle.

3. Do not allow anything to cover or clog the charger vents.

4. Always cover the battery pack terminals with the battery pack cover when the battery pack: is not

used.

5. Do not short the battery pack.

6. Do not touch the terminals with any conductive material.

7. Avoid storing battery pack in a container with other metal objects such as nails, coins, etc.

8. Do not expose battery pack to water or rain, A battery pack short can use large current flow, overheating, possible

burns and even a breakdown.

9. Do not store the machine and battery pack in locations where the temperature may reach or exceed 50°C (122°F)

10. Do not incinerate the battery pack even if it is severely damaged or completely worn out. The battery pack can

explode in a fire.

11. Be careful not drop, shake or strike battery pack.

12. Do not charge inside a box or container of any kind. The battery pack must be placed in a well ventilated area

during charging.

13. Do not leave batteries unused for extended period of time. Recharge the battery every 3~6 months and bring Li-

Ion battery to 40~80% charge level before storage.

14. Li-Ion batteries are sensitive to high temperature and should be kept in a cool, dry and out of direct light expo-

sure. Ideal temperature for operation and storage is below 77°F.

15. For extension of the battery lifetime, the lithium-ion battery is designed with the protection function to stop the

output.

In the case of described below, when using this product, even if you are pulling the switch, the motor may stop.

This is not malfunction but the result of protection function.

• When the battery power remaining runs out, the motor stops.

• If the tool is overloaded, the motor may stop.

In this case, release the switch of tool and eliminate causes of overloading. After that you can use it again.

• If the battery is overheated under overload work, the battery power may stop. In this case stop using the battery

and let the battery cool. After that you can use it again.

16. This product is designed with low voltage protection, which prevents the tool from over discharging and prolong

battery's lifespan.