Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Translation of the original instructions
Charging the Battery Pack (See Fig.3)
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown on the charger.
3. Push the battery pack into place and make sure the red light on the charger is "ON". The
battery pack is now starting the charging cycle.
4. After finish the charging cycle, the light will turn into green. The battery pack is now
ready for use.
5. Your new battery pack is not charged. You need to charge it before use.
6. Always use the specified charger to charge the battery. When the battery pack is inserted
into the charger correctly, the red light will come on and charging will begin.
7. When you charge a new battery pack or a battery pack which has not been used for a
long period, it may not accept a full charge. This is a normal condition and does not indi-
cate a problem. You can recharge the battery pack fully after discharging it completely a
couple of times.
8. Unplug the charger from the power source after finish the charge.
9. Please remove the battery from the unplugged charger for storage.
The LED Light on the Charger
Battery Low (Red light stays illuminated)
Battery charged 100% (Green light stays illuminated)
Battery Pack temperature is too hot or too cold
(Red light green stays illuminated)
1. Charger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack. When the
battery pack temperature returns to between 0°C(32°F) and 50°C(122°F), The charger will automatical-
ly begin charging.
3. If the battery charger does not work while the battery is mounted correctly, it is probable that the battery or char-
ger is malfunctioning
4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. Do not charge battery pack when environment temperature is below 0°C(32°F)or above 40°C(104°F)
6. While charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in the room for one hour
to warm up before starting the battery pack.
A cool battery may charge unsaturated.
7. Remove the plug after finishing the charge.
8. Do not use generator for charging the battery pack.
CORDLESS MINI SCREWDRIVER
Charger
EN
Fig.2
Fig.3
11
Publicité
Table des Matières
