Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Translation of the original instructions
CORDLESS MINI SCREWDRIVER
EN
TOOL OPERATION
Attaching The Bits (Bits excluded)
1. Insert the bit into the hole of the driver shaft.
2. To remove the bit, pull it out from the bit holder.
9.5mm(3/8")-11.5mm(7/16")
6.35mm(1/4")
Adjusting the torque
1. There are 16 sections of torque settings on the tool. Adjust the proper setting to the job.
2. Use drilling application, use the maximum torque setting.
Operating the switch:
Push the up portion of the main switch for reverse and lower portion for forward.
REVERSE
FORWARD
Main switch lock:
After use, set the main switch lock at the lock position to prevent accidental operation. (Fig.1)
Bit locking function:
With the switch at off, the bit is locked in place, and the tool can be used as manual screwdriver up to 250kg-cm.
There will be a little play in the driving shaft, but this is not a malfunction. (Fig.2)
Lock
Open
(Fig.1)
(Fig.2)
12
Publicité
Table des Matières
