Operate The Whole Unit - ARTHUR MARTIN AMP121 Manuel D'instruction

4.OPERATION INSTRUCTION

4.1 Operate the whole unit

There are two switches including power switch (1) and roll brush switch (2)
(see Fig.4-1). Press down power switch (1), the motor starts to run, the floor
brush indicator turns on and the appliance enters into working condition; Press
down the roll brush switch (2), the roll brush starts to work and it is used for
cleaning floor and carpet. Press the roll brush switch (2) again to make the roll
switch stop working. Press the power switch (1) if you want to make the
appliance stop working. During operation, please pay attention to electricity
quantity indicators (3), the indicators will extinguish gradually as the electricity
quantity reduces and the appliance will stop working automatically when all the
indicators extinguish.
1
4.2 Operate the sub-unit
Press down the sub-unit release button (4) (see Fig.4.2), grasp the handle of
sub-unit to remove it by following the arrow shown, and then press down the
sub-unit switch (5) (see Fig.4-3), the sub-unit enters into working condition, and
you can press the switch (5) to make it stop working.
If need to use small hair brush, please insert it into the suction nozzle of sub-unit
by following( Fig. 4-3), and then activate it again; If need to use flat suction spout,
insert it into the suction nozzle of sub-unit by following (Fig. 4-4), and then
activate it again.
All manuals and user guides at all-guides.com
2
Fig.４-１
１９
3