Install The Charger And Charger Stand - ARTHUR MARTIN AMP121 Manuel D'instruction

appliance by following the operation as below when use at the first time.
3.1 Assembling of Body and Handle
To insert the Handle (1) to Body (3) along the direction shown on illustration
Fig.3-1. And then fasten the Bolt (2) to the Body's (3) bolt socket along the
direction shown on illustration Fig.3-1 so that the Handle can be locked into the
Body safely.
3.2 Assembling of Body and Floor Brush
To insert the Floor Brush (1) to the Body along the direction shown on the
illustration Fig.3-2 until the Lock Button (2) locks.
1
Fig. 3-1

3.3 Install the charger and charger stand

Insert the charger into charger stand (see Fig. 3-3 and Fig.3-4), after it, use the
screws attached to fix the whole unit onto the wall or put in on a horizontal
surface.
Fig.3-3
All manuals and user guides at all-guides.com
2
3
Fig. 3-4a
１８
1
Fig. 3-2
Fig. 3-4b
2