Hama EWS-800 Mode D'emploi page 6

6.1. Automatic initial setup
• All available LCD segments on the display are displayed briefly after turning the measuring station on for
the first time.
• The base station then performs automatic initial setup. During setup, the base station performs measuring
station synchronisation, the pressure measurement values are stabilised and factory settings are set.
Note – Initial setup
• Initial setup takes approx. 3 minutes.
• Do not press any buttons during setup. Otherwise, values may not be transmitted correctly and there is
a risk of value errors and inaccuracies.
• The setup process is completed when the indoor (12, 14) and outdoor (18, 20) measurement data is
displayed
• After the first time the base station is switched on and successful transmission is established between the
base station and the measuring station, the clock will automatically search for a DCF signal. During the
search, the wireless symbol (27) will flash.
Display Searching for the DCF signal
Flashing display
Active
Constant display
Successful – signal is being received
No display Error – signal search ended
Note – Time settings
• If, during the first minute of the initial setup, no DCF signal can be found, the search is stopped and
repeated every two hours. The wireless symbol will go out.
• You can, however, set the time and the date manually.
• The clock automatically continues to search for the DCF signal on a daily basis. If the signal is received
successfully, the manually-set time and date are overwritten.
6
All manuals and user guides at all-guides.com