Operation; Switching Your Baby Monitor On Or Off; Volume; Battery Level Indicator/Battery Low Warning - switel BCC 48 Mode D'emploi

4 Operation

Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room
through the Parent Unit. You should also be able to "see" those sounds as the green and red sensor
lights around the top of the Parent Unit rise and fall with the sound levels.
If the connection between the Parent and Baby Units is broken at any time the green Link light
on the Parent Unit will flash slowly, the parent unit will beep to alter you that the link has been
lost and the green and red sensor lights will cease to react to any sounds. To re−establish the
Link, move closer to the baby unit or follow the directions in chapter "Troubleshooting".

Switching your Baby Monitor On or Off

Once connected to the power supply, your Baby unit and Parent Unit must both be switched on to
operate. To switch on, press and release the Power Key" on each Unit. To switch off, press and hold
the Power Key".

Volume

You can adjust the volume at which you hear your baby by using the Up" and Down" keys on the
side of the Parent Unit. Whilst you are adjusting the volume, the 5 green sound sensor lights act as an
indicator of the volume level.

Battery Level Indicator/Battery Low Warning

The Parent Unit will work up to 10 hours out of the Charger Pod, but this depends on the level of
charge in the batteries. If the charge is low, the red Power light on the Parent Unit will begin to flash
and you should return it to the Charger Pod to recharge the batteries. You can still use your Parent
Unit from the Charger Pod.
When you first switch on your Parent Unit, the green and red sensor lights will briefly indicate the
current charge level of the batteries in the following way:
8 lights illuminated
6 lights illuminated
4 lights illuminated
2 lights (alarm beep sounds)
A battery low warning beep will sound if the charge is low, or becomes low during use and the red
power light on the Parent Unit will begin to flash. If this occurs you should return the Parent Unit to the
Charge Pod to re−charge the batteries. You can still use your Parent Unit from the Charge Pod whilst
the batteries are charging.

Baby Alert

If the volume of your Parent Unit is turned all the way down and you are just using the lights to
monitor the noise levels in your baby's room, you will hear a warning beep on the Parent Unit should
the noise levels in your baby's room increase to the point that the red sound sensor lights are
showing. To stop the alert tone and turn off the Baby Alert feature, just turn the volume back up at the
Parent Unit.

Parent to Parent Paging

Useful if one parent is in the baby's room and needs contact the other. Also helps to find a mislaid
Parent Unit.
At the Baby Unit
Press and hold the "Page key ". The Parent Unit will emit a paging tone. To cancel the tone either
press and hold any key on the Parent Unit, or press the "Page key on the Baby Unit a second time.

Night Light

The Baby Unit has a one touch night light which emits a soft starry glow, providing comfort and
re−assurance for your baby and allowing you to see them in a darkened room.
At the Baby Unit
Press the "Night Light Key" on the top of the unit. A soft light will turn on gently. Press again and the
light will fade away.
All manuals and user guides at all-guides.com
= fully charged
= half charged
= battery is running low
= batteries need re−charging
− Operation −
37