Install Electrical Wiring - Bosch HDD80051UC Instructions D'installation

INSTALLATION

Install electrical wiring

CAUTION: Installation work and electrical wiring must
be done by qualifi ed person(s) in accordance with all
applicable codes and standards, including fi re-rated
construction.
CAUTION: Do not use an extension cord. If the
product power cord is too short, have a qualifi ed
electrician install a three slot receptacle.
1. Install a standard wiring box, with 3-pronged receptacle,
within reach of the downdraft's power cord.
2. Remove electrical panel wiring box cover. Secure
blower power cable to electrical panel wiring box with
U.L. approved strain relief.
Based on blower selected, go to the relevent
section:
A - Flex blower wiring
B - Remote blower wiring
A - Flex blower wiring
GREEN
WHITE
BLUE (cap off)
RED
M
ORANGE
BLACK
FLEXIBLE
BLOWER
3. Connect fl exible blower wires to wires in electrical panel
wiring box as shown. Cap off BLUE wire (LOW 1).
4. Replace wiring box cover.
English 20
From exterior or
in-line blower
ELECTRICAL PANEL
GROUND SCREW
WHITE (NEUTRAL)
RED (MED 2)
ORANGE (MED-HIGH 3)
BROWN (HIGH 4)
WIRING
BOX
B - Remote blower wiring
3. The following exterior or inline blowers can be used:
DHG6023RUC - 600 cfm (17 m
DHG6015NUC - 600 cfm (17 m
120 VAC • 60 Hz • 5.0 A (max.)
M
REMOTE 14/4 ROMEX
BLOWER OR CONDUIT
NOTE: Some blowers may come with plugs or connectors.
These should be removed and the 14/4 ROMEX or Conduit
wiring should be connected in and approved junction box.
As an alternative, the BSH 25-ft. Extension Cable Kit
(EXTNCB25W) and the Extension Cable Connection Kit
(EXTNSET4) can be used in place of the ROMEX or conduit
wiring. Please follow all required and recommended wiring
instructions in this manual and the extension cable kits.
4. Connect power wires to wires in electrical panel wiring
box as shown.
5. Replace wiring box cover.
/min) Remote Blower
3
3 /min) Inline Blower
ELECTRICAL PANEL
GROUND SCREW
WHITE (NEUTRAL)
RED (MED 2)
ORANGE (MED-HIGH 3)
BROWN (HIGH 4)
WIRING
BOX