Visonic TYCO KP-241 PG2 Guide De Démarrage Rapide page 4

General indications
The following table describes the meaning of LED indications that occur during
general use of the keypad:
Table 3. General LED indications
LED Indication
Red The command transmits successfully to
control panel. This occurs after every input.
Green with success tune Operation successful
Red with failure tune Operation failed
Arming indications
If the system is not ready to arm, or has a trouble or alarm condition, the Status
button flashes for a few seconds. See the
how to retrieve status information from the control panel.
Status requests
Press the Status button to request the status of your system

The LED blinks red once to indicate the status request, and then the Arm Away, Arm
Home, or Disarm button lights for a few seconds to indicate the arming status.
Table 4. Status request LED indications
LED Indication
Green Ready for arming
Red Not ready for arming.
This may mean that one or more zones are not secured.
Secure or bypass the zone to arm the system.
Yellow Trouble or active alarm.
Review and clear the trouble to arm the system.
Yellow blinking Low battery
4
Status requests
section for information on
Enrolling proximity tags
You can use proximity tags instead of user codes to arm and disarm the system. A
proximity tag can be assigned to each of the user codes 1 to 8.
1 Ensure the system is disarmed.
2 Enter the user settings menu on the control panel. Enter your user code.
3 Select the proximity tags option, and press OK.
4 Select Add new tag and press OK. The display reads ENROLL NOW or ENTR
ID:xxx-xxxx.
5 Press the Arm Away button on the keypad. The Arm Away button blinks.
6 Present the proximity tag to the tag reader area on the keypad within the
timeout period. If the tag enrolls successfully, a success tune sounds and the
display of the control panel reads DEVICE ENROLLED.
7 Optional: To assign the tag to another user, for example, User No. 5, enter 05,
or click the forward button until the display reads T05: Tag (Prox). Press OK to
confirm.
Controlling configured electrical appliances
The keypad allows remote control of electrical appliances connected to the control
panel's PGM output.
1 Press the PGM activation button.
2 To turn on the device, press the Arm Away button.
3 To turn off the device, press the Disarm button.
4 To toggle the device status, press the Arm Home button.
KP-241 PowerG wireless portable keypad
D-307871 KP-241 PG2 Quick Start Guide