Remington HC5780 Instructions D'utilisation page 5

ENGLISH
Comb Position
1
2
3
4
5
6
7
, TO ATTACH A COMB
• Hold the comb with its teeth upward
• Slide it onto and along the clipper blade until the front of the comb firmly sits against the
clipper blade.
, TO REMOVE THE COMB
• Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
F INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair. Do not
force it through quickly. If you are cutting for the first time, start with the maximum comb
attachment
STEP 1 – Nape of the neck
• Set the comb to 3mm or 6mm.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time
STEP 2 – Back of the head
• With the comb set at 12mm or 18mm, cut the hair at the back of the head.
STEP 3 – Side of the head
• Set the comb to 3mm or 6mm, trim sideburns. Then change the setting to 9mm and
continue to cut the top of the head.
Short Comb Long Comb
3mm 24mm
6mm 27mm
9mm 30mm
12mm 33mm
15mm 36mm
18mm 39mm
21mm 42mm
5