Exhaust Filter - Siemens VS Q8 Notice D'utilisation

19*
Fig.
•
Open the dust bag compartment lid.
•
Release the motor protection filter by pulling on the
side tabs and pull it out in the direction of the arrow.
•
Clean the motor protection filter by tapping out the
dirt.
•
If it is very dirty, the motor protection filter should
be rinsed.
The filter must then be left to dry for at least
24 hours.
•
After cleaning, refit the motor protection filter into
the appliance and lock it in place at the top. Close
the dust bag compartment lid.

Exhaust filter

The exhaust filter must be cleaned or replaced at least
once a year.
Replacing the micro-hygiene exhaust filter (Ultra Air
II hygiene filter)
20*
Fig.
•
Open the rear flap.
•
Unlock the filter holder by moving the locking tab in
the direction of the arrow.
•
Remove the foam filter* from the filter holder and
tap it out.
Replace the old micro-hygiene filter with a new one.
(This is included in the filter pack when you purchase
original dust bags).
Insert the foam filter into the filter holder.
•
Insert the filter holder into the appliance and lock it
in place.
Cleaning the HEPA exhaust filter (Ultra HEPA hygiene
filter)
The HEPA filter is designed so that it does not need to
be replaced, provided the appliance is used as inten-
ded in the household.
To ensure that the vacuum cleaner is working at its op-
timum power level, the HEPA filter should be rinsed out
after one year. The filtering action of the filter remains
intact, even if the filter surface becomes discoloured.
21*
Fig.
•
Open the rear flap.
•
Unlock the HEPA filter by moving the locking tab in
the direction of the arrow, and remove it from the
appliance.
•
Tap out the filter unit and rinse it under running wa-
ter.
Alternatively, the unit can be cleaned in a washing
machine at max. 30 °C using a gentle programme and
the lowest spin speed.
TIP: To protect other laundry items, put the filter
unit into a laundry bag.
•
Once the HEPA filter has dried completely (at least
24 hours), insert it back into the appliance and lock
it in place.
•
Close the rear flap.
All manuals and user guides at all-guides.com
After vacuuming fine dust particles (e.g. gypsum, ce-
ment, etc.), clean the motor protection filter by tapping
17
Fig.
it out or, if necessary, replace the motor protection fil-
ter and exhaust filter.
Care
Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the va-
cuum cleaner. The vacuum cleaner and plastic acces-
sories can be cleaned with an ordinary plastic cleaner.
!
The dust compartment can, if necessary, be cleaned
with a second vacuum cleaner or simply wiped with a
dry cloth or dusting brush.
Subject to technical modifications.
Do not use abrasive materials, glass-cleaning agents
or all-purpose cleaning products. Never immerse the
vacuum cleaner in water.
* Depending on model
33