Breville the Duo-Temp Pro BES810 Manuel D'instructions page 13

CARE & CLEANING
DECALCIFYING
After regular use, hard water can cause
mineral build up in and on many of the
internal components, reducing water flow,
power of the machine, and affecting the
quality of coffee.
We advise decalcifying the machine on a
regular basis (every 2-3 months) using a
mixture of white vinegar and water.
Use the following as a guide:
SOLUTION FOR DECALCIFYING
Diluted Solution (for softer water).
• 1 part white vinegar
• 2 parts cold tap water
Concentrated Solution (for harder water)
• 1 part white vinegar
• 1 part cold tap water
NOTE
If an alternative decalcifying agent is
used, please follow the manufacturer's
instructions specified.
24
DECALCIFYING THE MACHINE
• Ensure the Control Dial is in the
'Standby' position, the POWER
On/Off button is off and unplugged.
• Remove the filter holder and pour the
mixture of white vinegar and water into
the water tank.
• Plug the machine into the power outlet.
• Ensure POWER On/Off button is on
and the Control Dial is set to the
'Standby' position.
• Place a large container under both the
Group Head and the Steam Wand.
• Set the Control Dial to the 'Espresso'
position and let half the mixture of
white vinegar and water run through
the Group Head.
• Set the Control Dial to the 'Steam'
position and allow the remaining liquid
to run through the Steam Wand. When
the liquid stops flowing, set the Control
Dial back to the 'Standby' position.
• After decalcifying, remove the water
tank and rinse thoroughly then re-fill
with fresh cold water.
• To rinse the machine, run half the
water through the Group Head and half
through the Steam Wand.
• The machine is ready for use.
PAGE HEADER..... CARE & CLEANING
CLEANING THE STEAM WAND
1 2 3
Run steam to clear milk Wipe steam wand after Clean hole with pin
from wand after texturing each use
CLEANING FILTER BASKETS
Should the fine holes in the filters become
blocked follow the steps below:
Place the filter into the portafilter.
1.
Run water through the machine with
the filter and portafilter in place,
without any ground coffee.
The pin tool can be used to clear
2.
the filter basket holes.
For a thorough clean of the filters,
3.
dissolve a cleaning tablet in hot
water and soak filters overnight.
CLEANING THE OUTER HOUSING /
CUP WARMING PLATE
The outer housing and cup warming plate
can be cleaned with a soft, damp cloth. Then
polish with a soft, dry cloth.
Do not use abrasive cleansers, pads or cloths
which can scratch the surface.
CLEANING THE DRIP TRAY
The drip tray should be removed, emptied
and cleaned at regular intervals.
Wash the drip tray with warm soapy water,
using a non-abrasive washing liquid, rinse
and dry thoroughly. The drip tray base and
cover are dishwasher safe.
4 5
Remove tip Soak tip overnight then
re-attach
CLEANING THE STORAGE TRAY
The storage tray can be removed after the
drip tray is removed then cleaned with
a soft, damp cloth (do not use abrasive
cleansers, pads or cloths which can scratch
the surface).
STORING YOUR MACHINE
Before storing, press the POWER button
to 'Off', turn the Control Dial to 'Standby'
and unplug.
Insert all accessories into position or into
the storage tray.
Store upright. Do not place anything on top.
WARNING
Do not immerse power cord, power
plug or appliance in water or any other
liquid. The water tank should never be
removed or completely emptied during
decalcifying.
25