Xylem FLOJET FLO 5.0 Mode D'emploi page 4

Installation/Mounting
CAUTION: Not For Continuous Duty, Intermittent Duty Only
CAUTION: Installation Notes: To avoid the risk of fire. Be sure that
the area where pump is installed is isolated from gas, fuel tanks,
electrical wiring looms or flammable substances. Failure to do so
may cause injury or death.
CAUTION: Installation Notes: To avoid the risk of fire. Do not install
this product if visible damaged. If damage exposes electrical
contacts, electrical sparks could ignite fuel fumes. Failure to do so
may cause injury or death.
1: Select pump location. Pump must be installed in a dry, ventilated
area.
Figure 2.
Horizontal
2: Connect fittings supplied
with the pump to the system
plumbing. Use ½" (13mm)
I.D. flexible hose (preferably
braided or reinforced) to
reduce vibration through the
plumbing system (Figure 1).
Use hose clamps on the slip on
barb hose connectors.
Important: Install strainer in the
pump inlet to protect valves
from debris.
3: Fasten pump to a flat surface. If
mounting vertically; install with
pumphead down (Figure 2)
Do not over tighten screws to
allow rubber mounts to absorb
vibration.
4: Install inlet (A) and discharge
(B) fittings. Firmly push slide
clips (C) forward to lock fittings
in place. – Figure 3
Figure 3.
Inlet Strainer (A)
Figure 4.
4
Vertical
Discharge (B)
NOTE: Do Not Submerge
Figure 1.
To discharge
point
Pumpgard
Strainer