Assembly And Use - FEUERHAND PYRON PLATE Mode D'emploi

ASSEMBLY AND USE

STEP 1:
Arrange the three arms of the support frame
on an even surface (table) and fix them with
the provided screws, the washers placed
under the screw heads and nuts. Make sure
that all plate hooks are facing in an upward
direction.
STEP 2:
Ensure the Pyron has a steady stand before
placing the support frame on top. It should
be positioned on an even, solid ground. Place
the fixed support frame, with the grooves
pointing upwards, completely into the up-
per part of the Pyron. Minimise possible
clearance between the frame and Pyron by
carefully adjusting each arm and tighten
the screws.
STEP 3:
Place the Pyron Plate on the support frame
and insert the cooking support into the re-
spective cavity of the Pyron.
COMMISSIONING
During its first use, the plate will arch. Due
to the material, it cannot be predicted if the
DEUTSCH
All manuals and user guides at all-guides.com
arching will take place up or downwards. If
the plate is arched upwards please remove
the cooking support using fireproof gloves
and place it on a heat-resistant surface. Turn
the plate over so that it is arched downwards
and carefully reinsert the cooking support.
SEASONING
Before using the Pyron Plate for the first time,
you have to season the plate to develop a
patina. Pour some highly heatable oil onto
the plate until it is completely covered. To
prevent the oil from dripping off the plate,
you can add some salt. Heat up the Pyron
Plate and cover the surface with raw potato
slices (with or without peel). Let the potatoes
roast at great heat until they are dark brown,
turning them over several times. After some
time, the steel will get darker and develop
the typical patina. Remove the oil, potatoes
and salt with a scraper. Let the grilling plate
cool down and clean it with hot, clear water.
Afterwards, the plate can be lubricated for
maintenance. The plate is now ready to use.
USE
When using the Pyron with the Pyron Plate,
the fire may stop burning for a short mo-
ment with increasing smoke development.
This is due to the Pyron being filled to high
or the ventilation being too low. To reignite
the gasified wood, fill in small, dry timber or
use a match too ignite the smoke. The smoke
development will stop immediately.
ENGLISH FRANÇAIS