Switching The Door Mounting - Amica AC 151iA+ Mode D'emploi

All manuals and user guides at all-guides.com
Switching the Door Mounting Side
To switch the door mounting side :
• Set the control dial to „0" and unplug the mains cord.
Take out all the food from the ap plian ce.
• Remove the adjustment feet.
• Unscrew the lower hinge (Phot. 12) and the element fastening the foot (Phot. 13)
• Take out the refrigerator chamber door.
• Unscrew the upper hinge bolt and dri ve it in the second hinge in the extreme ope-
ning (Phot. 14).
• Mount the refrigerator door by inserting the upper hinge bolt into the door bush and
close the door.
• Tilt the appliance back, the magnetic ga sket will hold the door.
• Unscrew the lower hinge bolt, drive it into the second ope ning of the hinge (Phot. 12(1)).
• Insert the lower hinge gasket into the lo wer door bush and fasten the door with
three screws on the left side of the housing.
• Tighten the element fastening the foot with three screws, replacing the left hinge.
• Drive the adjustable feet in.
• Tighten the handles opposite to the hinges, plug the openings with the plugs taken
out from the opposite side or from the replacement kit.
• Check the tightness of the gasket after switching the door mounting.
Use a strip of plain paper, put it between the gasket and the body and close the door.
Shut in any pla ce between the body
and the gasket, the strip should perceptibly resist when pulled or moved (Phot. 15).
• Turn on the refrigerator.
Refrigerator type AC 151iA+ cannot be built-in under an 850 mm high table
top.
THE APPLIANCE ASSEMBLY IN A FUR NI TU RE NI CHE IS TO BE
CARRIED OUT AC COR DING TO THE FOLLOWING „ FURNITU-
- for the appliance
RE BUILD-IN AS SEM BLY IN STRUC TION"
type: AC 151iA+
23