Before You Start - Amica AC 151iA+ Mode D'emploi

All manuals and user guides at all-guides.com

Before You Start

Placement of the product
• Unpack the product; remove the tape securing the door and the accessories. Remove
the remains of the glue, if any, with delicate cleaning detergent.
• Do not throw the Styrofoam element of the packaging away. Should you have to
transport the product again, secure the refrigerator with the Styrofoam ele ments, the
plastic foil, and Scotch tape.
• Wash the inside of the refrigerator cham ber and the accessories with lukewarm
water with some di sh wa sher li qu id and then wipe it and dry.
• Place the refrigerator in a dry, ventilated place, out of sun, far from such heat sources
as the oven, central heating radiators, etc.
If it is impossible to place the re fri ge ra tor away from a heat source, use an ap pro pria te
insulation board or make sure the distance from the refrigerator is:
- at least 3 cm from electric or gas co okers,
- at least 30 cm from oil or coal-fired stoves.
• If you place the refrigerator next to another refrigerating of freezing unit, the lateral
distance be twe en the ap plian ces
should be at least 2 cm.
• Make sure the product is placed level ad ju sting two turn-in front feet of the re fri ge ra tor.
• Once placed, make sure the refrigerator is not standing on the power supply cord.
• The AC 151iA+ refrigerator are equipped with a cover top and can be built-in in a set
of kitchen cabinets with a standard height of 85 cm.
Install a ventilation grid in the back part of the cover top prior to the appliance placement.
The installation should be done by pushing the fasteners located in the front part of the
ventilation grid into the openings in the back part of the co ver top (Phot 6).
• For easy opening of the re fri ge ra tor door the distance be twe en the side (the hin ges side) and
the room wall should be at least 5 cm.
• Any modification of the refrigerating system is prohibited. Be especially careful
not to do any damage to the capillary tube (Phot.7 (1)) located in the re cess next to
the compressors. The tube cannot be bend, straightened or coiled. Damage of the
capillary tube by the user waives the guarantee of the re fri ge ra tor.
Connection to the power sup ply sys tem
• We advise setting the temperature con trol dial to „0" before the connection.
• The appliance should be connected to a system of alternating current,
230 V / 50 Hz, through a properly installed soc ket.
If the fixed power supply cable is damaged, it should be replaced at the
manufacturer or at an authorized servicing outlet, or by a qualified person to
avoid danger.
19