Dimplex IGNITE XL BOLD XLF5017-XD Mode D'emploi page 21

Operation
Brightness
Flame Theme
Ambient Light
Sensor
Timer
Factory Reset
Press repeatedly to cycle through the brightness and flicker modes.
Solid L - Low Brightness
Solid H - High Brightness
Cycle L - Low Brightness with flickering media and overhead lights
Cycle H - High Brightness with flickering media and overhead lights
Press repeatedly to cycle through the 7 different flame themes:
1 - Base with orange and blue accents
2 - Base with orange accents
3 - Base with blue accents
4 - Blue
5 - Orange
6 - Base
7 - Orange and blue
Press to turn the ambient light sensor on or off.
The ambient light sensor will automatically adjust the brightness of the fireplace lights
based on the ambient light in the room.
Press repeatedly until the desired number of hours of the timer is displayed. When
this function is active, the fireplace will turn off after a set amount of time. The timer
can be set from 30 minutes (display will show .5) to 8 hours in intervals of 30 minutes.
To turn the timer off, press
While the timer is active, press the timer button to see the time remaining.
Press and hold and
factory default. This action will also disconnect the unit from the Wi-Fi network if
connected. This action must be performed on the hidden touch controls.
repeatedly until 0 appears on the display.
at the same time for 3 seconds to reset all the settings to
21