Dimplex IGNITE XL BOLD XLF5017-XD Mode D'emploi page 12

Installation
2. Lift the firebox into the opening in the frame using the
handles on the back of the fireplace.
!
NOTE: Ensure the instructions for Preparing the
Firebox for Installation (p. 10) have been completed
prior to installation.
3. Remove the screws that secure the electrical cover to
complete the wiring. (Figure 11)
4. Complete the wiring according to instructions in the
Electrical Installation section (pages 14–15). Reinstall
the electrical cover after completing wiring.
5. Level the firebox. A bubble level is included in the
hardware kit provided.
6. For multi-unit installations, install the joining brackets
between adjoining fireplaces. (Figure 12)
Figure 12
Figure 13
Mounting brackets
(center brackets not present on
XLF5017-XD and XLF6017-XD units)
12
Figure 11
Adjoining brackets for
multi-unit installations
(included in XLFXDLINK,
sold separately)
7. Secure the mounting brackets to the framing on
both the top and bottom using the provided wood
screws. (Figure 13) The mounting brackets will
prevent the firebox from shifting in the framing.
8. Install finishing material up to the trim.
(Figures 14 and 15)
CAUTION: Do not drill into firebox housing.
9. Finish the installation using the finishing materials
of your choice.
10. Complete the installation using the instructions in
the following sections: Mirrored Glass Installation
(p. 17), Arranging Media (p. 17), Front Glass
Installation (p. 18), and Side Glass Installation
(p. 18).
Electrical Cover Electrical Cover
www.dimplex.com