Russell Hobbs 13617 Instructions page 4

Household use only
Before using for the first time
Turn to "care & maintenance" on page 6, and clean the smoothie maker and
1
attachments thoroughly, to remove manufacturing dust, etc.
Preparation
2 Sit the motor unit on a dry, firm, level surface, near a power socket.
Route the cable so it doesn't overhang, and can't be tripped over or caught.
3
4 Press and release
5 Put the plug into the power socket.
Fit the jug
6 When you fit the jug to the motor unit, the illuminated panel will glow, and will stay on till
you remove the jug, or unplug the smoothie maker.
7 In normal use, you should treat the jug, jug base, and tap as a single unit. They should
only be separated when you come to clean them.
8 You may fit the jug with the tap to the right or left.
9 There are two sets of padlock markings
and one at the front.
10 Hold the jug above the motor unit, with the tap to the side you want.
11 Align the open padlock
12 Lower the jug on to the motor unit, then turn the jug to align the closed padlock
the .
Fill the jug
13 Lift the lid off the jug.
You'll find it's quite stiff (it has be, to keep the ingredients from escaping when you turn
14
the motor on).
15 Put the ingredients into the jug.
16 These should be a mixture of liquids and solids (frozen ingredients count as solids).
Don't fill past the 1.7 mark. If you do, the contents may force the lid off when you start
17
the motor.
Fit the lid
18 Put the lid on the jug, and press it down.
Don't use the smoothie maker without fitting the lid. The contents may escape; you may
19
hurt someone; you may be tempted to put a hand into the jug.
to ensure everything's off.
facing you with the
4
on the base of the jug, one at the back,
on the motor unit.
with