Dexter 220MFS2.5 Manuel D'instructions page 136

FR
2. SAFETY INSTRUCTIONS
ES
4. POWER TOOL USE AND CARE
PT
a) Do not force the power tool. Use the correct power tool for your application.
The correct power tool will do the job better and safer at the rate for which it was
IT
designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power
EL
tool that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the
PL
power tool before making any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce the risk of starting the power tool
UA
accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
RO
unfamiliar with the power tool or these instructions to operate the power
tool. Power tools are dangerous in the hands of untrained users.
EN
e) Maintain power tools and accessories. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended could
result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease.
Slippery handles and grasping surfaces do not allow for safe handling and control of the
tool in unexpected situations.
5. SERVICE
a)
Have your power tool serviced by qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
MULTIFUNCTION SANDER SAFETY WARNINGS
•
WARNING Contact with or inhalation of harmful / toxic dusts arising from sanding lead
painted surfaces, woods and metals can endanger the health of operator and
bystanders.
136