Waeco mobitronic RV-24 Instructions De Montage Et De Service page 32

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
_RV-24_RV-27.book Seite 32 Dienstag, 18. Mai 2004 11:25 11
All manuals and user guides at all-guides.com
Mounting the camera
8.2
Mounting the camera
If installing the camera alters the vehicle height or length specified
in the vehicle documents, your vehicle must be inspected by the
appropriate authorities.
Make sure that you are in possession of documents verifying that
your vehicle has passed this inspection.
Warning!
Select a location for the camera and attach it so securely that
it cannot under any circumstances fall off and injure bystanders
(e.g. by being knocked off by branches brushing over the roof of
the vehicle).
Observe the following installation instructions:
To provide a suitable viewing angle, the camera must be attached at
a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting
the camera.
Ensure that the installation location of the camera is sufficiently firm
(e.g. to prevent the camera from being knocked down by branches that
may brush over the roof of the vehicle).
Mount the camera horizontally and in the middle of the rear of the vehicle
(see a, page 6).
Always use the supplied insulation pad (8 5, page 5). This prevents
residual current caused by a poor earth connections in the vehicle.
Residual current can cause lines of interference in the picture or
humming in the loudspeakers or even damage components.
The most secure type of attachment is with screws fitted through the
body. Please observe the following instructions:
– There must be sufficient space for the mounting procedure behind the
chosen installation location.
– Suitable measures must be taken to prevent water penetrating through
any holes made (e.g. by using screws and sealant and/or spraying the
outer attachment parts with a sealant).
– The location on the body where you wish to attach the camera must
be rigid enough to allow the camera to be tightly fastened.
Check beforehand that there is sufficient room for the drill head to come
out on the other side (see 2, page 4).
32
RV-24, RV-27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mobitronic rv-27

Table des Matières