Lexmark X820e MFP Mode D'emploi page 32

Input tray
24
Maintaining your MFP
Cleaning the scanner the scanner
pick pads
Pick pads
Two screws
1
k pads
2
3
4
5
6
7
8
9
10
For instructions on maintaining the
printer, refer to the printer publications
CD. D.
Lift the input tray.
Remove the two screws. move the two screws.
Lower the roller plate and pull it
straight out.
Dampen a clean, lint-free cotton
cloth with water.
Wipe the two pick pads.
Align the tabs on either side of the
roller plate with the grooves inside
the paper exit area.
Insert the right tab into the right
groove, and then slip the left tab
into the left groove.
Tilt the roller plate up and slanted
slightly down on the right side.
Slide the plate back until it snaps
into place.
Install the two screws to secure
the plate.