LaserLiner PowerCross-Laser 8 S Mode D'emploi page 21

Adjustment of X/Y axes
The LEDs of the X-axis (15) light up in red.
The LEDs of the Y-axis (16) light up in green.
Adjust vertical slope, to a max. of 3° (Z axis)
6
Slope function > 3°
7
Steeper slopes can be set using the angle plate, which is available as an
optional extra. Use a crank tripod for this. Refer to the illustrations below.
TIP: Set the angle plate to the zero position and allow the device to align
itself automatically. Then press the auto/man button to switch the automatic
sensor off. Finally, incline the device to the angle you require.
Slope adjustment > 3°
PowerCross-Laser 8 S
2x
2x 2x
2x
21
EN